D-0120794-C – 2019/11
Orion Rotary Chair Installation Instructions Page 12
3.3 Booth Ceiling Assembly
Assemble the booth ceiling either upright or on the floor. Note: One ceiling wing will line up with a hole in the
corner of the main ceiling base. When assembling the booth ceiling on the floor, set the assembly on top of
the cardboard boxes to prevent damage or scratches to the ceiling. Offset the wing 1-2 inches from the main
section and slide the wing in a downward position. Use the rubber mallet to align the pieces, taking care only
to strike along the outside edge of the wing to prevent breaking the pieces.
Caution: Attach the wings using a rubber mallet by striking only the flat edge of the wing or the
plastic edge may crack.
Using rubber mallet to attach the wings is shown in the
figure
Once the wing is aligned to the base section, secure the wing using the ceiling screws. Repeat the step for
the second wing.
Securing Wing to Ceiling
Using two people, walk the assembled booth ceiling above the booth and lower it into place. Do not lift the
ceiling by the wings to prevent damage to the ceiling. Caution must be taken not to damage the two wires
that located on top of the booth door.
To Next Page
Loading...
