Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 53
1.2.5.2.6 Siren tamper
If the Siren tamper option is set to Yes, the tamper alarms from sirens assigned
to this area also have to be tested.
1.2.5.2.7 Frequency
The Frequency setting defines, how often the user is requested to perform the
user walk test prior to setting an area. The following options are available:
Table 16: Walk test frequency
User walk test is not requested
User is asked to perform the walk test prior to each set
User is asked to perform the walk test prior to the first set each day
User is asked to perform the walk test prior to the first set each week
User is asked to perform the walk test prior to the first set each month
Note: For walk test purposes Advisor Advanced stores information on any zone
activation for 4 hours. Therefore if the zone was activated during the last 4 hours
before walk test, it is not included into the list of zones required to test. If each
walk test zone was activated during this time, the walk test is not requested.
1.2.5.2.8 Need to set
If Need to set option is set to On, the requested user walk test is obligatory. The
area cannot be set until the walk test is passed.
1.2.5.2.9 Reduced walk
Reduced walk test period is a time period before reduced walk test start, in which
particular zone activation excludes this zone from the list of zones being tested.
The following options are available:
• 4h: Reduced walk test only includes zones that were not active during last
4 hours.
• Set2set: Reduced walk test only includes zones that were not active since the
last set.
See “1.2.5.1 Walk test start” on page 51 for more details on reduced walk test.
To Next Page
Loading...
