Chapter 3: Programming
CDC4 Door Controller Installation and Programming Manual 77
The following sections describe each step of the recommended programming
sequence above. In the descriptions, Downloader is used for programming
CDC4.
Note: If ATS8600 will be used for management of CDC4, then some aspects of
programming should not be done in Downloader, since ATS8600 will be
responsible for those aspects. ATS8600 can be used to configure and manage:
• Holidays
• Schedules
• Door groups
• Users
In addition to the initial setup and programming of CDC4, ongoing management
can be performed via management software.
For information on management via Downloader, see ATS8500 Downloader
Online Help.
To Next Page
Loading...