Interlogix CDC4 - Lock Power

Chapter 1: Installation
CDC4 Door Controller Installation and Programming Manual 29
Lock power
There are two cable sockets providing extra lock power (Figure 12 on page 13,
items 22 and 32), if required. The sockets are for easy connection to expander
boards that support the connection, such as the CDC-2DWIF Dual Wiegand
Interface.
Connect a 2-way lock power cable (supplied with the expander board) to one of
the 2-pin plug-in lock power sockets.
Refer to Figure 15 on page 27 for example connections of 2-way lock power
cables from CDC4 to an expander board (items A and C).
Door lock relay wiring
Figure 17 below details the wiring for the relay terminal blocks.
Figure 17: Door lock wiring options (relay shown deenergised)
Lock powered by controller
Power to lock door lock
Lock powered by controller
Power to unlock door lock
Lock powered externally
Power to lock door lock
Lock powered externally
Power to unlock door lock
Note: A suppression diode such as 1N4004 must be used in door lock circuits.
The diode must be collocated with the lock.
When the locks are powered by the door controller, refer to “Output fusing and
user current draw” on page 38.
+12
COM
NC
NO
0 V
+12
COM
NC
NO
0 V
+12
COM
NC
NO
0 V
-
+
PSU
+12
COM
NC
NO
0 V
-
+
PSU