Chapter 1 — Using the Computer
22 CN3 Series Mobile Computer User’s Manual
The Read-to-Work indicator (blue light) is for the SmartSystems
Foundation application that is part of a wireless network using all
Intermec devices. For more information, see
“Remotely
Configuring the Computer Using SmartSystems Foundation”
on page 49 or contact your Intermec representative. Selected
application software programs may also use the blue light, either
steady or flashing, for other purposes.
Scanning Bar Codes
Use the area imager to scan and enter bar code data. If your CN3
has an area imager, you cannot have the color camera option too.
The CN3 supports reading 1D and 2D images, composite and
postal codes. These bar code symbologies are enabled by default
on the CN3: Code 39, Code 128, UPC-A, UPC-E, EAN-8,
EAN-13, and DataMatrix.
If you are using bar code labels that are encoded in a different
symbology, you need to enable the symbology on the computer.
Use Intermec Settings to enable and disable symbologies. For
help, see
“Configuring the Computer With Intermec Settings”
on page 48.
Ready-to-Work
indicator
Blue The CN3 is suspending or resuming
with the display turned off.
Blinking
blue
You have successfully loaded and
activated TE 2000.
The TE 2000 application is loaded, but
is inactive.
Off The TE 2000 application is missing or
disabled.
Note: The blue light may stay on for up to 30 seconds, but will
usually turn off after less than 10 seconds. During this time, do
not toggle the CN3 on or off and do not remove the battery, or
you may corrupt the CN3.
Understanding the LEDs (continued)
LED Color Description
To Next Page
Loading...
