Intermec CN3 Series

Chapter 3 — Configuring the Computer
52 CN3 Series Mobile Computer User’s Manual
Configuring the Computer to Communicate With a Wireless Scanner
This section explains how to configure the computer to
communicate with Bluetooth wireless scanners. The computer
ships with a Bluetooth association label attached to the left side.
Scan the association label to quickly connect the computer to the
Bluetooth wireless scanner, such as the SF51 or SR61.
To configure Bluetooth communications on the computer
1 Select Start > Settings > the System tab > Intermec Settings.
2 Select Communications > Bluetooth.
3 If you want to allow incoming connections from wireless
scanners, you must enable these two parameters:
•Discoverable
• Connectable
4 Save your changes and exit Intermec Settings.
To connect to the wireless scanner using the association label
1 Using your wireless scanner, scan the Bluetooth association
label on the side of the CN3.
2 The CN3 prompts you to enter the passcode for your scanner.
The default passcode for Intermec Bluetooth scanners is
0000.
3 Tap Finish.
To connect to the wireless scanner using Bluetooth Scanner Wizard
1 Select Start > Settings > the System tab > Bluetooth Scanner
Wizard.
2 Tap Add Device. The wizard advances to the next screen.
Note: If for some reason the Bluetooth association label does not
work, you can follow the procedure for configuring the computer
from Intermec Settings at the end of this section.
Note: If you do not want to allow incoming connections,
make sure both parameters are disabled.