Chapter 1 — Using the Computer
CN3 Series Mobile Computer User’s Manual 5
The battery is fully charged when its battery status LED shows a
steady green.
To charge the battery
• Insert the battery into a quad battery charger, a single dock, or
attach external power to the CN3 with the battery installed.
For information on these accessories, see “Accessories” on
page 131
.
Use the next table to understand how long it will take to charge
your batteries in some of the CN3 charging accessories.
Removing and Installing the Battery
To maximize the time allowed to replace the main battery pack,
put the CN3 in a suspend mode before removing the battery
pack.
To remove and install the battery
1 Press and hold the Power button for about 2 seconds until the
CN3 turns off.
2 Press the battery release tab to the left until the battery
releases, and then lift it away from the CN3.
Removing the Battery in a CN3
Charging Times for CN3 Batteries
Charging Accessory Model Charging time
CN3 Quad Battery Charger AC14 5 hours or less
CN3 Single Dock AD10 5 hours or less
Battery release tab
To Next Page
Loading...
