Chapter 5 — Troubleshooting and Maintaining the CN3
124 CN3 Series Mobile Computer User’s Manual
• Cold booting the CN3
•Clean booting the CN3
Warm Booting the CN3
You may need to perform a warm boot to correct conditions
where an application stops responding to the system.
To warm boot the computer
•Press and hold the Power button for 10 seconds.
The computer systematically shuts down, restarts, and goes
through the initialization process.
Cold Booting the CN3
In some cases where the computer completely stops responding,
it may be necessary to perform a cold boot. Because cold booting
may result in data loss, only use this method if all other recovery
methods have failed.
To cold boot your CN3
1 Press the Power button to suspend the CN3.
2 Remove the battery pack from the CN3.
3 Press the Reset button on the back of the CN3.
Locating the Reset button on the CN3
Note: Cold booting the CN3 does not guarantee that cached disk
data will be saved, so transactional data may be lost during the
reset. All other data is preserved.
Reset button
To Next Page
Loading...
