Chapter 1 — Using the Computer
CN3 Series Mobile Computer User’s Manual 27
4 Close the miniSD/SIM card slot door and insert the two
screws.
5 Replace the battery pack and then press the Power button.
Once the door to the miniSD is opened and closed (for changing,
installing, or removing the SIM or miniSD card), the CN3
performs a cold boot.
Setting Up GPS on Your CN3
If your CN3 comes equipped with an integrated Global
Positioning System (GPS) receiver, it can deliver standards-based
National Marine Electronics Association (NMEA) data strings to
GPS applications. However, Intermec recommends that you use
the GPS Intermediate Driver (GPSID) instead of directly
accessing the GPS hardware. The GPSID is a Microsoft software
component that interacts between applications and the GPS
hardware.
Using the GPSID allows Intermec support for Extended
Ephemeris, which enhances GPS performance by:
• reducing the amount of time it takes your GPS receiver to
acquire a fix.
• eliminating the need to obtain precise satellite data
information from the GPS satellites.
miniSD card slot
Do not over-torque the two screws that secure the card slot
door. You can damage the door.
To Next Page
Loading...
