Intermec CN3 Series

Chapter 3 — Configuring the Computer
CN3 Series Mobile Computer User’s Manual 67
• Tap List to toggle to detailed information showing what
ping touched what host and the RTT (Round Trip Time).
Configuring the Phone
The CN3 supports two types of cellular phone technology:
• CDMA EV-DO Rev 0
•GSM/EDGE
With a radio module installed in the CN3, you can send and
receive telephone calls as well as transmit data through wide-area
(WAN) cellular networks.
The CN3 provides a phone speaker, microphone, and
speakerphone. It also supports the use of a Bluetooth headset or
hands-free kit. The factory default setting for the phone is
disabled.
After you have turned on the phone and activated it, you can
customize the features of the phone and network settings. For
help, refer to the online help on your CN3.
Turning On the Phone Using the Wireless Manager
You can use the Wireless Manager application to turn on the
phone if Microsoft Zero Configuration is enabled. If you have
Intermec Security enabled, you cannot access the Wireless
Manager. For information on enabling and configuring
Microsoft security, see
“Configuring Microsoft Security” on
page 96.
You can use the Wireless Manager to enable and disable
Bluetooth, Wi-Fi, and the phone if it is built into your CN3.
To turn on the phone using the wireless manager
1 Tap Start > Settings > the Connections tab > Wireless
Manager.
2 In the Wireless Manager, tap Phone. The phone turns on.