Intermec EasyCoder 501 – Service Manual Ed. 7
16
Chapter 2
2. Front and Keyboard
2.1 Front
The moulded front part is attached to the center section using four
#T20 screws and to the bottom plate by two #T20 screws. The
front moulding is provided with holes for mounting a cutter con-
nector (4-pin female DIN-type) and a memory card adapter.
At the top part of the front moulding, there is a cavity for the
keyboard/display assy. This assembly is affi xed by means of
two grub screws which can be loosened using a 2 mm hexagon
wrench.
Keyboard/Display assy.
Front Moulding
Provision for
Cutter Connector
Provision for
Memory Card Adapter
Grub Screws
Cutter Connector
(fi tted as standard)
To Next Page
Loading...
