Intermec EasyCoder 501 - Dismantling

Intermec EasyCoder 501 – Service Manual Ed. 7
36
Chapter 6 Label Slack Absorber
6.2 Dismantling
The label slack absorber unit is fi tted to the center section using
two #T20 Torx screws inserted from the electronics compartment.
The shaft should be screwed into the fl ange with a tightening
torque of 5 Nm.
#T20 Torx Screw (2x)
#T10 Torx Screw
Torsion Spring
Shaft
Flange
#T10 Torx Screw
Spacer
Grip
Edge Guide