Intermec EasyCoder 501 – Service Manual Ed. 7
96
Chapter 12 Paper Cutter
Standard Cutter
•
Switch off the power and remove the power cord.
• Open the printer’s front hatch.
• Hold the printer fi rmly and press the front hatch sideways to the
left as to disengage the hinges.
• Remove the hatch completely.
• If the printer is fi tted with a label taken sensor (LTS), it has to
be removed before the cutter can be fi tted, see Chapter 11.
• Fit the cutter unit to the vacant hinges. Make sure that the lock-
ing plate snaps into the groove of the right-hand hinge and that
the angled plate at the bottom of the cutter is inserted under the
printer’s bottom plate.
• Fit the cable from the cutter unit into the DIN connector above
the memory card slot on the printer’s front.
12.4 Installation
Press sideways
DIN Connector
Press sideways
Cutter Unit
To Next Page
