221Intermec EasyCoder 501 – Service Manual Ed. 7
Appendix 1
Intermec Shell v4.01 Standard
ARE YOU SURE ?
Y=H DOWN/ N=H UP
RAM MEMORY
CLEARED
HD/PP HD/PP HD/PP
HU/PP
ARE YOU SURE ?
Y=H DOWN/ N=H UP
SER-COM RESET
PERFORMED
Enter
SHELL
SER-COM RESET
SHELL
CLEAR RAM MEMORY
SHELL
REBOOT
Exit Shell and enter last selected application!
STD I/O CHANNEL
UART1
STD I/O CHANNEL
UART2
STD I/O CHANNEL
UART3
STD I/O CHANNEL
CENTRONICS
LSS ADJUST
CONTRAST
5
SEL. APPLICATION
optional applic.
SEL. APPLICATION
Fingerprint 6.14
SHELL
SETUP
See Technical
Manual
SEL. APPLICATION
WINDOWS DRIVER
PRINT=SHELL
5 sec. v.4.01
PRINT=SHELL
4 sec. v.4.01
PRINT=SHELL
3 sec. v.4.01
PRINT=SHELL
2 sec. v.4.01
PRINT=SHELL
1 sec. v.4.01
Last selected
application is started
Default:
Fingerprint v6.14
w. std I/O= "uart1:"
Last selected application is started
No action taken
POWER ON
Printhead Up/
Press Print key:
Proceed to next menu
Legend:
SHELL
SEL. APPLICATION
SEL. APPLICATION
Direct Protocol
SEL. APPLICATION
optional applic.
SEL.APPL rom:
LINE_ALY.PRG
HU/PP: SET
HD/PP: VIEW
SEL. APPLICATION
LABELSHOP
Enter Terminal Setup
by transmitting T T T
to printer, when menus
marked with grey
are displayed!
HU/PP
Printhead Down/
Press Print key:
Accept displayed
option and proceed
HD/PP
SHELL
TEST LABEL
SHELL
TESTFEED
Perform a Testfeed, i.e. feed out a blank copy and
autoadjust the label stop sensor.
Print a series of test labels in a loop.
Press Print for each new label.
Print a list of current setup values.
Resets comm. setup
to default values on
all serial channels.
Clears printer's
RAM memory.
SHELL
PRINT SETUP
HD/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HD/PP
HD/PP
HD/PP
HD/PP HD/PP HD/PP
HD/PP
HD/PP
HD/PP
HD/PP
HD/PP
HD/PP
HD/PP HD/PP
HD/PP
HD/PP
HD/PP
HD/PP
HD/PP
HU/PP
HU/PP
HD/PP
HD/PP
SEL. APPLICATION
CURRENT APPL.
HD/PP
HD/PP
HD/PP
HD/PP
HD/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
HU/PP
To Next Page
Loading...
