Intermec EasyCoder PC4 User Manual

 

On/Off Switch
e On/Off switch is located at the back of the printer.
Feed Key
e Feed key can be used in two ways:
• Tapping
• Holding
When power is first applied and the printer is loaded with media (and
possibly ribbon), tapping the Feed key will initiate a formfeed, that is,
media will be fed out to the top of next label or tag.
When power is first applied with no labels loaded, holding the Feed key
will cause the media to be continuously fed out until the key is released.
is mode is useful when replenishing the media supply.
After the media has been threaded through the printer, tapping the Feed
key 3 more times (for a total of 4 taps) will cause a formfeed.
Controls and Indicators
e EasyCoder PC4 is controlled by the operator by means of an On/
Off switch, a “Feed” key, and a multi-color indicator lamp.
Indicator lamp
Feed key
E
a
s
y
C
o
d
e
r
C4
F
e
e
d
P
o
w
e
r

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing