Intermec EasyCoder PC4 User Manual

 
Safety Instructions
1 Please read these safety instructions carefully.
2 Please keep this User’s Guide for later reference.
3 Please protect this equipment from humidity.
4 Check the voltage of the power source before connecting the equip-
ment to the power outlet.
5 If the equipment is not used for long time, disconnect the equipment
from the AC voltage to avoid damage by transient over voltage.
6 Never pour any liquid into any openings, this could cause fire or elec-
trical shock.
7 Never open the equipment. For safety reason, the equipment should
only be opened by qualified service personnel.
8 If one of the following situations arises, get the equipment checked by
a service personnel:
a. Liquid has penetrated into the equipment.
b. e equipment has been exposed to moisture.
c. e equipment does not work well or you can not get it work
according to the User’s Guide.
d. e equipment has dropped and been damaged.
e. If the equipment has obvious signs of breakage.
9 For use only with power supply Intermec/SPN-470-24.

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing