Intermec EasyCoder PC4 User Manual

 

Label Gap Sensor
Adjustment
e EasyCoder PC4 printer is fitted with a label gap sensor that detects
slots between tickets and tags, or gaps between labels, as the media is fed
past the sensor during printing. us the firmware can determine the
length of the tags or labels and control the media/ribbon feed accord-
ingly.
e label gap sensor is a center-aligned photoelectric sensor that mea-
sures the light that passes through the media path. e transparency of
the liner of a label supply may differ between batches, making it difficult
for the sensor to discriminate between labels and liner. When this occurs,
the indicator lamp will switch from green to orange, indicating that
sensor should be adjusted by entering the Test Mode, as described below.

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing