Plain Continuous Stock
e EasyCoder PC4 can use continuous stock without any detection
slots or black marks. e printer must be set for continuous stock by the
Q command (see Intermec ESim v6.XX, Programmer’s Reference Manual).
e length of each copy is decided by the size of the print image and any
additional media feed is decided by the Q command.
Continuous stock cannot be used in the Test (Dump) Mode.
← a → Tag or strip width:
Maximum: 116.0 mm (4.57 inches)
Minimum: 25.0 mm (1.00 inches)
To Next Page
Loading...
