Intermec EasyCoder PC4 User Manual

 

6 Press the Feed key and keep it pressed and at the same time switch
on the power to the printer (also see “Test Mode” on page 29). A test
label will be printed. Check the version number on the test label to
verify that the upgrading has been successful.
7 Tap the Feed key once to leave the Dump Mode and return to normal
operation.
8 You can use the same memory cartridge to upgrade several printers by
moving the cartridge from printer to printer and repeat this procedure
for each printer. Be careful not to change the position of the memory
cartridge switch until all printers have been upgraded.
9 e cartridge can be used as a normal memory expansion cartridge
after the upgrading is completed. Move the switch back to normal
position, insert the cartridge in a printer, and switch on the printer.
e memory cartridge will then be formatted automatically.

Intermec EasyCoder PC4 Specifications

General

Resolution	203 dpi
Power Requirements	100-240 VAC, 50-60 Hz
Print Method	Direct Thermal
Max Print Width	4.09 inches (104 mm)
Max Print Speed	4 inches per second
Max Print Length	39 inches
Media Type	Roll-fed, die-cut, continuous, fanfold, tags, tickets
Media Width	1.0 - 4.65 inches
Media Thickness	0.06 mm (0.00236 in) to 0.18 mm (0.00708 in)
Interface	RS-232
Memory	4 MB Flash, 8 MB SDRAM
Operating Temperature	5°C to 40°C (41°F to 104°F)
Storage Temperature	-4°F to 140°F (-20°C to 60°C)
Humidity	10 to 90% non-condensing