Intermec EasyCoder PD4 User Manual

Intermec EasyCoder PD4—User’s Guide 11
Chapter 2—Installation
Connections
Power
1 Place the printer on a level surface, near an AC outlet. You should be
able to easily access the printer to load media and to remove the print
-
out.
2 Both the printer and the host computer must be switched off while
they are being connected.
3 Connect the power cord between the receptacle on the rear plate and
to the electrical outlet (100 to 240 VAC).
Computer
e EasyCoder PD4 is fitted with one 36-pin Centronics socket for the
parallel interface, one 9-pin D-style subminiature (DB9) socket for the
RS-232 serial interface port and one class B connector for the USB inter
-
face port (see Appendix C).
Parallel Interface
Use the parallel interface with Intermec LabelShop or the Intermec Inter-
Driver. e parallel port supports error signal and paper end signal.
RS-232 Serial Interface
Use the serial interface with Intermec LabelShop or the Intermec Inter-
Driver. You can also use it for programming (see Intermec ESim v5.xx for
EasyCoder PD4, Programmer’s Reference Manual). Before you can use the
serial interface, you may need to set up the communication parameters,
such as baud rate, parity, etc. as described in Chapter 5, “Printing.”
USB Interface
Use the USB interface with an USB-compatible version of the Intermec
InterDriver for printing. e USB interface works in the same manner as
RS-232 and is useful for error message handling (see Intermec ESim v5.xx
for EasyCoder PD4, Programmer’s Reference Manual)
.

Intermec EasyCoder PD4 Specifications

General

Brand	Intermec
Model	EasyCoder PD4
Category	Label Maker
Language	English

Summary

Before You Begin

Safety Summary

Outlines critical safety information for handling and operating the printer.

Energized Equipment Safety

Warns against working on energized equipment without authorization and proper safety.

Safety Icons and Warnings

Explains the meaning of various safety icons and symbols used in the manual.

1 Introduction

Description of EasyCoder PD4

Provides a detailed description of the printer's features and capabilities.

Safety Warnings

Lists essential safety precautions to follow before operating the printer.

2 Installation

Connections

Covers power connection and various computer interface options like Parallel, RS-232, and USB.

Controls and Indicators

Explains the functions of control lamps, display, control keys, and beeper.

3 Starting Up

Switching on the Printer

Procedure for powering on the printer and initial startup messages.

Printing a Test Label

4 Loading Media

Tear-Off (Straight-through) Loading

Peel-Off (Self-strip) Loading

Thermal Transfer Printing and Ribbon Load

5 Printing

Controlling the Printing

Setup Methods and Navigation

Setup Options

6 Options

7 Troubleshooting

Error Handling and Codes

Explains printer error handling, LED indicators, beeper signals, and error codes.

Clearing Media Jams

Detailed procedures for clearing media jams in different printer areas.

Entering Dump Mode

8 Maintaining the Printer

Printhead Cleaning

Detailed steps and warnings for cleaning the printer's printhead.

External Cleaning

Printhead Replacement

Step-by-step guide for replacing the printer's printhead.

Media Jams

9 Adjustments

Printhead Adjustments

Printhead Dot Line Position

Label Gap Sensor Adjustments

Ribbon Tension and Shield Adjustment

D Firmware Upgrading

Firmware Upgrading Requirements

Firmware Upgrading Instructions