Intermec EasyCoder PD4—User’s Guide 77
Appendix B—Media Specifications
Self-Adhesive Labels
⇐ a ⇒ Media Width (including liner)
Maximum: 118.0 mm (4.65 inches)
Minimum: 25.0 mm (1.00 inches)
⇐ b ⇒ Liner
e backing paper must not extend more than a total of 1.6 mm (0.06
inches) outside the labels and should protrude equally on both side.
⇐ c ⇒ Label Width (excluding liner)
Maximum: 116.4 mm (4.58 inches)
Minimum: 23.8 mm (0.94 inches)
⇐ d ⇒ Label Length
Maximum:
8 dots/mm (203.2 dpi) 1270 mm (50 inches)
11.81 dots/mm (300 dpi) 558.8 mm (22 inches)
Minimum:
8 dots/mm (203.2 dpi) 5 mm (0.2) inches)
11.81 dots/mm (300 dpi) 5 mm (0.2 inches)
⇐ e ⇒ Label Gap
Maximum: 26.0 mm (1.02 inches)
Recommended: 3.0 mm (0.12 inches)
Minimum: 1.2 mm (0.05 inches)
e Label gap sensor must be able to detect the extreme front edges of
the labels. It can be moved 0 to 57 mm (0 to 2.24 inches) from the inner
edge of the media (see Chapter 9).
Paper Type Setup
• Gap paper
To Next Page
Loading...
