Intermec EasyCoder PD4—User’s Guide 79
Appendix B—Media Specifications
Tickets with Gaps
⇐ a ⇒ Media Width
Maximum: 118.0 mm (4.65 inches)
Minimum: 25.0 mm (1.00 inches)
⇐ b ⇒ Copy Length
Maximum:
8 dots/mm (203.2 dpi) 1270 mm (50 inches)
11.81 dots/mm (300 dpi) 558.8 mm (22 inches)
Minimum:
8 dots/mm (203.2 dpi) 5 mm (0.2) inches)
11.81 dots/mm (300 dpi) 5 mm (0.2) inches)
⇐ c ⇒ Detection Position
Variable: 0 to 57 mm (0 to 2.24 inches)
⇐ d ⇒ Detection Slit Length
e length of the detection slit (excluding corner radii) must be mini-
mum 2.5 mm (0.10 inches) on either side of the detection position (e).
⇐ e ⇒ Detection Slit Height
Maximum: 26.0 mm (1.02 inches)
Recommended: 3.0 mm (0.12 inches)
Minimum: 1.2 mm (0.05 inches)
Paper Type Setup
• Gap paper
Note: Do not allow any perforation to break the edge of the
media as this may cause the media to split and jam the printer.
To Next Page
Loading...
