Intermec EasyCoder PD4 User Manual

50 Intermec EasyCoder PD4—User’s Guide
Chapter 7—Troubleshooting
Entering the Dump Mode
In the Dump Mode, the printer prints all received ASCII characters
including control characters (ASCII 00-31 decimal). ere is automatic
line-wrapping and if a label becomes completely filled, the dump contin
-
ues on a new label. is facility is useful for debugging.
Enter the Dump Mode like this:
1 Switch off the power to the printer.
2 Press and hold the Feed key while you switch on the power again.
3 e Feed key must be pressed for more than 2 seconds after power up
(else a test label will be printed).
4 When the printer is in Dump Mode, this message will be displayed
provided the printer is fitted with an optional display:
In the Dump Mode, you can reset the printer to its default setup values
by pressing the Cancel key for 3 seconds or more.
To exit the Dump Mode and enter the Direct Mode, tap the Feed key.

Intermec EasyCoder PD4 Specifications

General

Brand	Intermec
Model	EasyCoder PD4
Category	Label Maker
Language	English