Chapter 4 — Enabling and Configuring Symbologies
90 SR60 Scanner Programmer’s Reference Manual
Label Length Format
The next two sections explain how to set the Interleaved 2 of 5
Label Length Format to either the Variable Length or Fixed
Length Format.
Variable Length Format
You can set the Interleaved 2 of 5 symbology to Variable Length
Format.
To set the Interleaved 2 of 5 Variable Length Format
1 Identify the minimum length setting you want to make. You
may choose any even number between 02 to 50
characters.
2 Scan the SET bar code.
3 Scan the Enable Variable Length Format bar code.
4 Scan the Set Minimum Label Length bar code.
5 Using the Digits bar codes on page 93, scan the digits to set
the minimum label length you identified in Step 1.
Don’t Transmit ---------
Transmit ---------
END-----------------------------------
Note: For this symbology, the scanner decodes up to 50
characters, but the actual length read varies depending upon
the interface type, bar code physical size, and print quality.
To Next Page
Loading...
Need help?
General
