Chapter 2 — Configuring Interface Settings
42 SR60 Scanner Programmer’s Reference Manual
USB Interface
Scan the following bar codes to enable the USB interface and
configure the keyboard country code.
To enable the USB interface and configure the keyboard country code
1 Identify the keyboard country code you will use. See the next
table, “Keyboard Country Code for USB Interface.”
2 Scan the START bar code on page 43.
3 Scan the Enable USB and Configure Keyboard Country
Code bar code.
4 Using the Digits bar codes on page 44, scan the digits to set
the keyboard country code you identified in Step 1.
5 Scan the Lower Case Enable bar code.
6 Scan the END bar code on page 43.
END------------------------------------
If you have the USB interface, you must scan these bar codes
to enable the interface, or certain conditions will result in data
corruption.
Keyboard Country Code for USB Interface
Country
Code for
Windows 98/XP/2000
Code for
IMAC
Belgium 734 742
Denmark 738 746
France 523 526
Germany 525 528
Italy 529 530
Japan 759 Not available
Norway 737 745
Poland 733 Not available
To Next Page
Loading...
Need help?
General
