Chapter 5 — Configuring General Features
146 SR60 Scanner Programmer’s Reference Manual
Configuring the Low Power Mode
When enabled, Low Power mode causes the scanner to power
down completely between trigger pulls. This results in very low
idle current, lowering the energy needs of the scanner. However,
the microcontroller must reboot with every trigger pull, which
causes a very small delay in scanning. Intermec recommends that
you use this mode only when the scanner is connected to a
battery-powered terminal.
1 Seconds ---------
1.2 Seconds ---------
1.5 Seconds ---------
END------------------------------------
Note: This feature is not affected when you restore the
factory defaults by scanning the Return to Factory Defaults
programming bar code. You must manually enable or disable
this feature.
Note: Low Power mode is not supported by the USB interface.
To Next Page
Loading...
Need help?
General
