Chapter 2 — Configuring Interface Settings
SR60 Scanner Programmer’s Reference Manual 37
Software Handshaking
XON/XOFF is software handshaking that allows the host to
control data transmission. If the host sends an XOFF command
to the scanner, the scanner does not send the bar code data until
it receives an XON command from the host. If the host sends the
XOFF command during data transmission, the host receives
additional characters for no more than 2 ms. (The timing varies
slightly, depending on the baud rate you select.)
Step #1 ---------
Step #2 ---------
END------------------------------------
Enable XON/XOFF Control
SET-------------------------------------
Step #1 ---------
To Next Page
Loading...
Need help?
General
