Chapter 3 — Configuring Label Transmit Settings
SR60 Scanner Programmer’s Reference Manual 53
Setting a Prefix or Suffix
The method you use to set a prefix or suffix depends on your
scanner interface:
•USB Interface
• Wand Emulation, Keyboard Wedge, RS-232, or Decoded
Interface
The scanner does not transmit a prefix or suffix character if its
hex value is set to zero.
Set Suffix ---------
0 ---------
END------------------------------------
Note: For the USB interface, the global character that is added at
the end of every scan is an End of Message (EOM) character, not
a Postamble (suffix). For help, see “Setting an EOM for a USB
Interface” on page 56.
To Next Page
Loading...
Need help?
General
