EasyManuals Logo

Intermec SR61T2D User Manual

Intermec SR61T2D
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
Chapter 1 — Learning About Programming the SR60 Scanner
12 SR60 Scanner Programmer’s Reference Manual
Trouble Scanning the Bar Codes in This Manual
If you are having trouble scanning the bar codes in this manual,
make sure you follow these guidelines:
Review the scanning instructions in the SR60 Scanner Quick
Start Guide (P/N 930-141-xxx) which shipped with the
scanner.
If you are using the XLR version, hold the scanner at least
1.2 m (4 ft) from the bar code because this is a long range
scanner.
If you see more than one red marker beam, aim the center
beam on the bar code.
Move the marker beam horizontally across the page toward
the bar code to avoid passing the marker beam over other bar
codes.
Contacting Intermec Product Support
If you need to contact Intermec Product Support for help with
your SR60 scanner, follow the instructions in
“Global Services
and Support” on page xi.
Make sure you have this information before you contact Intermec
Product Support:
Scanner configuration number: Look for the C/N number on
the label above the trigger.
Cable part number: Look for the part number on the label
attached to the cable.
For help understanding your warranty, see “Warranty
Information” on page xi.
Note: By default, the marker beam is enabled for the
XLR version and disabled for the SR version. For more
information, see “Configuring the Marker Beam” on
page 144.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intermec SR61T2D and is the answer not in the manual?

Intermec SR61T2D Specifications

General IconGeneral
BrandIntermec
ModelSR61T2D
CategoryBarcode Reader
LanguageEnglish

Related product manuals