Chapter 4 — Enabling and Configuring Symbologies
SR60 Scanner Programmer’s Reference Manual 97
• The Enable Variable Length Format bar code on page 100
directs the scanner to read all labels from minimum label
length to 50. If you select variable length format, there is one
more bar code label to scan:
• The Set Minimum Label Length bar code on page 100
selects the minimum label length that the scanner will
recognize. The minimum label length for this symbology
must be between 03 and 50. Set the Minimum Length as
high as your application allows.
• The Enable Fixed Length Format bar code on page 101
directs the scanner to read only one or two label lengths. If
you select fixed length format, there are three bar code labels
for programming your scanner to read either one or two fixed
lengths. The labels are:
• The Set First Fixed Length bar code on page 101 instructs
the scanner that the next two programming labels scanned
will define the first fixed label length. This setting must be
between 03 and 50 characters.
• The Set Second Fixed Length bar code on page 101
instructs the scanner that the next two programming
labels scanned will define the second fixed label length.
This setting must be between 03 and 50 characters.
• The No Second Fixed Length bar code on page 102
configures the scanner to recognize only the first fixed
length.
Start/Stop Characters
Start/Stop Characters can be either Send or Don’t Send
depending on your host’s interface requirement. Refer to your
host user’s manual to identify your system requirements.
Start/Stop Match
Start/Stop Match can be enabled or disabled.
Note: For this symbology, the scanner decodes up to 50
characters, but the actual length read varies depending upon the
interface type, bar code physical size, and print quality.
To Next Page
Loading...
Need help?
General
