Chapter 2 — Configuring Interface Settings
SR60 Scanner Programmer’s Reference Manual 19
Keyboard Wedge Interface
This section describes these PC Keyboard Wedge interface
parameters:
• Interface Selection
• Connect to a Laptop
•Caps Lock
•Country Mode
• Intercharacter Delay
•Quiet Interval
For help changing other settings for this interface, see:
• Chapter 3, “Configuring Label Transmit Settings,” on
page 47.
• “All Symbologies Supported by All Interfaces” on page 70.
• Chapter 5, “Configuring General Features,” on page 139.
PC Keyboard Interface Selection
The SR60 scanner supports a variety of PC keyboard interfaces.
Find your PC Keyboard Interface in the first column and note
the corresponding Interface Type in the second column.
For your convenience, the third column lists the corresponding
cable or cables you can use to connect the SR60 scanner.
Note: If you configure the transmission parameters so that a label
results in no actual data to send, the label will be accepted,
beeped, and no data transmitted.
Note: Keyboard Wedge Interface is not supported by the USB
interface.
To Next Page
Loading...
Need help?
General
