Chapter 2 — Configuring Interface Settings
SR60 Scanner Programmer’s Reference Manual 31
RS-232 Communication Parameters
This section describes these RS-232 communication parameters:
•Baud Rate
• Data Format Settings: Data Bit, Parity Bit, and Stop Bit(s)
•Handshaking
• Hardware Handshaking (CTS/RTS)
• Software Handshaking (XON/XOFF)
• ACK/NAK Options
• Intercharacter Delay
For help changing other settings for this interface, see:
• Chapter 3, “Configuring Label Transmit Settings,” on
page 47.
• “All Symbologies Supported by All Interfaces” on page 70.
• Chapter 5, “Configuring General Features,” on page 139.
Baud Rate
Scan the following bar codes to select the Baud Rate. Only one
Baud Rate selection may be active at any one time. The last Baud
Rate bar code you scan during a programming session is the
setting that is stored when you scan the END bar code.
END------------------------------------
Note: RS-232 Communication Parameters are not supported by
the USB interface.
SET-------------------------------------
To Next Page
Loading...
Need help?
General
