Chapter 3 — Configuring Label Transmit Settings
SR60 Scanner Programmer’s Reference Manual 49
Setting Global Prefixes and Suffixes
This section describes how to set global prefixes and suffixes.
Setting Global Prefixes
You may add one or two prefix characters to the standard label
format. To add more than two prefix characters, contact Intermec
Product Support for Full Label Edit (FLE) options.
To set global prefixes
1 Identify your specific system requirements.
2 Using the ASCII table on page 164, identify the ASCII
character(s) and the corresponding hex code(s) for the prefix.
For example, suppose you want to send the two prefix
characters STX (start transmit) and SP (Space). The ASCII
chart shows that STX equals 02 hex and SP equals 20 hex.
3 Scan the SET bar code on page 50.
4 Scan the Set Prefix bar code.
5 Using the list of bar codes that starts on page 160, scan the
four digits corresponding to the hex values you chose in
Step 2.
For this example, you would scan 0, 2, 2, and 0.
Note: In the Global Prefix and the Global Suffix columns, 00
indicates no character.
Do not use these procedures if you have a USB interface.
For a USB interface, see “Setting a Prefix or Suffix for a USB
Interface” on page 54.
Note: Successful programming requires four digits for the
label ID.
To Next Page
Loading...
Need help?
General
