Appendix A — Factory Default Configuration
156 SR60 Scanner Programmer’s Reference Manual
General Features Defaults
Feature Default Your Setting
Green LED Idle State Off
Beep On or Off On
Power-up Beep Enable
Beep Volume High
Good Read Beep Frequency High
Good Read Beep Duration 100 ms
When to Beep After Decode
Marker Beam Enable/Disable Enable (XLR version)
Disable (SR version)
Marker Beam Duration 500 ms
Low Power Mode Disable
Half Angle Enable (XLR version)
Disable (SR version)
Note: The Low Power Mode and Half Angle features are not
affected when you restore the factory defaults by scanning
the Return to Factory Default Settings programming bar code.
You must manually enable or disable these features. For help,
see “Configuring the Low Power Mode” on page 146 or
“Configuring the Half Angle” on page 149.
To Next Page
Loading...
Need help?
General
