Interroll DL Series - Interfaces to Other Devices

Version 1.2 (08/2022) en
Translation of original operating instructions 9 of 64
Safety
Rotating parts
• Do not reach into areas between drum motor and conveyor belts or roller chains.
• Tie long hair together.
• Never wear loose clothing.
• Never wear jewelery, such as necklaces or bracelets.
Hot motor parts
• Do not touch the surface of the drum motor. It can result in burns, even under regular operating temperature.
• Install corresponding warnings on the conveyor.
Working environment
• Do not use the drum motor in explosive atmospheres.
• Remove equipment or material which is not required from the workspace.
• Wear safety shoes.
• Clearly specify and monitor the way materials are placed on the conveyor.
Faults during operation
• Regularly check the drum motor for visible damage.
• In case of fumes, unusual noise or blocked or damaged materials, stop the drum motor at once and ensure that the
RollerDrive cannot be started accidentally.
• Contactqualiedpersonnelimmediatelytondthesourceofthefault.
• During operation, do not step on the drum motor or the conveyor/the system in which it is installed.
Maintenance
• Checktheproductregularlyforvisibledamages,unusualnoiseandrmseatingofttings,screwsandnuts.An
additional maintenance is not required.
• Do not open the drum motor.
Accidental motor start
• Take care during installation, maintenance work and cleaning or in the event of a drum motor fault: The drum
motor could start up unintentionally.
2.6 Interfaces to other devices
Hazardsmayoccurwhileintegratingthedrummotorintoacompletesystem.Thesearenotpartofthismanualand
havetobeanalyzedduringthedesign,installationandstartupofthecompletesystem.
• After assembling the drum motor in a conveyor module, check the whole system for a new potential dangerous
spot before switching on the conveyor.
• Additional constructive measures may be required.