Interroll DL Series - Initial Startup and Operation; Initial Startup; Checks before the Initial Startup; Operation

42 of 64
Version 1.2 (08/2022) en
Translation of original operating instructions
Initial startup and operation
9 Initial startup and operation
9.1 Initial startup
The drum motor may be put into operation only if it is correctly installed and connected to the power supply and all
rotatingpartshavebeenttedwiththecorrespondingprotectivedevicesandguards.
9.1.1 Checks before the initial startup
Thedrummotorislledwiththecorrectoilquantityatthefactoryandreadyforinstallation.Priortotheinitialstartup
of the motor, the following steps have to be performed:
1. Ensure that the motor type plate matches the version ordered.
2. Ensure that no contact points exist between objects, conveyor belts and rotating or moving parts.
3. Ensure that the drum motor and the conveyor belt can move freely.
4. Ensure that the belt features the correct tension according to the recommendations from Interroll.
5. Ensurethatallboltsaretightenedaccordingtothespecications.
6. Ensure that no additional dangerous areas arise due to interfaces to other components.
7. Ensure that the drum motor is correctly wired and connected to the voltage supply with the correct voltage.
8. Check all safety devices.
9. Ensure that no bystanders are in dangerous areas around the conveyor.
10. Ensure that the external motor protection is correctly adjusted to the rated motor current and a corresponding
switchingdevicecanswitchothemotorvoltageatallpolesiftheintegratedthermalcircuitbreakertrips.
9.2 Operation
CAUTION
Rotating parts and accidental starting!
Riskofcrushingforngers.
¾ Do not reach between drum motor and belt.
¾ Do not remove the protection device.
¾ Keepngers,hairandlooseclothingawayfromthedrummotorandthebelt.
¾ Keep wristwatches , rings, necklaces, piercings and comparable jewelry away from the drum motor and the
belt.