User’s Manual of netMod Network Termination Unit
netMod does not activate / deactivate the supplementary / additional services on the
S-bus. Signalling and data on the S-bus are transferred transparently through the netMod.
The subscriber, following the user’s instructions of the terminal device connected to the
S-bus, can activate / deactivate the supplementary / additional services, separately on
each device.
You have to confirm that the Supplementary and Additional
Services described below have been activated in the ISDN
Exchange of the ISDN service provider.
The operator of the ISDN exchange has to activate supplementary / additional services
after a subscriber’s request. The subscriber then, can activate / deactivate these services
on each analogue port, depending on his/her needs.
The settings made for the supplementary / additional services by
pressing the keys of the analogue devices are permanently
stored in netMod. The settings made using AT commands are not
permanently stored in netMod (excluding the “Multiple
Subscriber Number”) and are not restored after resetting the
device. To permanently store these settings, you have to follow
the process described in paragraph “Permanent Storage of the S-
Registers Settings” page 71.
21
To Next Page
Loading...
