Intracom netMod - Call Forwarding on Busy (CFB)

User’s Manual of netMod Network Termination Unit
12.2. Call Forwarding on Busy (CFB)
The function of this service requires the assignment of MSN on the corresponding port.
When a netMod port is busy, all incoming calls that concern a subscriber number (MSN) of
the called subscriber port, are forwarded to another pre-selected number destination.
• The CFB service for the subscriber number of an analogue port that is stored in a
memory location X (X=’1’ or ‘2’ or ‘3’) is activated by pressing:
*67*DialNumber*X#
X takes the values ‘1’ or ‘2’ or ‘3’

DIAL NUMBER is the subscriber number to which the call will be
forwarded after the (CFB) service activation.
• The CFB service for the subscriber number of an analogue port that is stored in a
memory location X (X=’1’ or ‘2’ or ‘3’) is deactivated by pressing:
#67*X#
X takes the values ‘1’ or ‘2’ or ‘3’.
• The inspection on whether the call forwarding on busy service is supported by the local
ISDN exchange for the subscriber number of an analogue port that is stored in memory
location X (X=‘1’ or ‘2’ or ‘3’) is done by pressing:
*#67*X#
X takes the values ‘1’ or ‘2’ or ‘3’
Then the subscriber will hear on the handset
• a continuous tone or a voice message when the service is supported
• an interrupted tone or a voice message when the service is not supported.

The [*X] parameter is optional for all the above commands. If no
value is assigned for the [*X] parameter, the subscriber number
that is forwarded is the one that is stored in memory location ‘1’.
3
0