Intracom netMod - Call Hold and Enquiry Call (CH); Three Party Conference (3 PTY)

User’s Manual of netMod Network Termination Unit
3. Call Hold and Enquiry Call (CH)
The subscriber can have an active call on line and make a second call from the same
analogue port.
The key combinations are listed below:
• The key FLASH to place the active call on hold and wait for the dial tone.
• After the dial tone, the enquiry call can take place by dialling the called subscriber
number and waiting for an answer.
Then the following keys can be pressed:
• The keys
FLASH 2 to switch between the two calls
or
• The keys
FLASH 1 to release the active call and retrieve the call on hold
or
• The keys
FLASH 0 to clear the call on hold.
4. Three Party Conference (3PTY)
When the subscriber has an active call on line and a second call on hold, then by pressing:
• The keys
FLASH 3 establish a three party conference for the active call and the
held call.
If the subscriber has a three party conference established then by pressing:
• The keys FLASH 2 split up the three party conference. There is again an active call
on line and a second call on hold.
24