User’s Manual of netMod Network Termination Unit
2. Call Waiting (CW)
When this service is activated on an analogue port, the subscriber during his/her active
call receives a tone indicating an incoming call.
The incoming call is placed in a waiting state for a certain time period and the subscriber
can answer this waiting call by pressing:
• The keys FLASH 2 to accept the waiting call and place the active call on hold (the
same key combination is used to switch between the two calls).
• The keys
FLASH 1 to accept the waiting call and release the active call.
• The keys
FLASH 0 to reject the waiting call.
When the subscriber ignores the call waiting indication, the waiting call is rejected after a
certain time period.
The call waiting can be activated on each analogue port by pressing *43#
The call waiting can be deactivated on each analogue port by pressing
#43#
Note that this service is initially activated on both analogue ports
of netMod.
23
To Next Page
Loading...
