Intracom netMod - Additional Services Using at Commands; Delayed Clear Back; Activation of Functional; Keypad Protocol

User’s Manual of netMod Network Termination Unit
Additional Services using AT Commands
Some of the Additional services can be activated / deactivated through the use of AT
Commands.
1. Delayed Clear Back
By using AT commands write on the S83-Register the proper values to activate /
deactivate this service on each of netMod’s analogue port (ab1 or ab2).
ATS83=0 activates the service on both analogue ports ab1 and ab2.
ATS83=1 deactivates the service on the analogue port ab1 and activates the service on
the analogue port ab2.
ATS83=2 activates the service on the analogue port ab1 and deactivates the service on
the analogue port ab2.
ATS83=3 deactivates the service on both analogue ports ab1 and ab2.

Note that this service is initially activated on both analogue ports
of netMod.
2. Activation of Functional / Keypad Protocol
Alternatively, you can activate the KEYPAD protocol by writing on the S100-Register the
value ‘1’. To restore the FUNCTIONAL protocol, write on the S100-Register the value ‘0’.
7
8