User’s Manual of netMod Network Termination Unit
3. Delayed Clear Back
When a call has been established and the B-party (called subscriber) has placed the
handset on-hook, an inspection of 90 seconds is initiated. If during this inspection the
subscriber places the handset off-hook, the active call will be restored. When this
inspection of 90 seconds ends, the connection is released.
• To turn Delayed Clear Back on press **70#
• To turn Delayed Clear Back off press
**71#
Note that this service is initially activated on both analogue ports
of netMod.
4. Incoming Call Management
Incoming call Management is specific for using in analogue PBX’s. This feature is ideal
when you have not MSN numbers available or programmed in netMod. We can program
that only one POTS will be ringing at incoming calls.
Four different options are supported:
**03*0# :Broadcast. Both ab1 and ab2 are ringing.
**03*1# :ab1 preferred.
**03*2# : ab2 preferred.
**03*3# : ab1 and ab2 ring alternatively.
5. Hook Flash Detect Time for Analogue Adapters
In order to set the Flash detect time you can also use the DTMF code: **25*Time#
<time> value must be assigned in steps of 10ms (as is in the corresponding S register).
To restore the default value (700 ms) press: **25#
34
To Next Page
Loading...
