Invacare G50 - Page 75

Invacare
®
- G50
SERVICE INSTRUCTIONS
75
• Before the fixation nuts of the gas pressure
springs can be loosened, the front fixation
screws (1) of the lateral handles should be
loosened and removed, using an Allen
key 6 mm, so that the seat support can be
moved further forward. This takes the
pressure off of the gas pressure springs.
• Carefully remove the protective plastic caps
from the fixation nuts of the gas pressure
springs, using the small, flat screwdriver.
• Loosen and remove the fixation nuts of the
gas pressure springs, using two open-end
spanners 13 mm .
• Carefully remove the front spring locking plate
(1) of the seat angle adjustment, using the flat
screwdriver.