Invacare G50 - 7.9.2 Assembly; 7.9.3 Adjusting the hand brake

Invacare
®
- G50
SERVICE INSTRUCTIONS
63
7.9.2 Assembly
• Re-assembly is done in reverse order.
• Secure the Bowden cable, using new cable ties.
7.9.3 Adjusting the hand brake
After replacing a Bowden cable, the hand brake must be adjusted.
• Jack up wheelchair with wooden blocks under
the drive unit. The wheels must be able to
move freely.
• Pull the Bowden cable tight by pressing the
lever arm of the brake upward, while you pull
the steel cable downward.
• Tighten the nut on the Bowden cable
clamping screws with an open-end
spanner 10 mm, while you continue to press
the lever arm of the brake upward with your
other hand.