Invacare G50 - 7.12 Replacing electronics components; 7.12.1 Replacing the power module

Invacare
®
- G50
SERVICE INSTRUCTIONS
77
7.12 Replacing electronics components
Requirements:
• Open-end spanner 8 mm
• Crosstip screwdriver
7.12.1 Replacing the power module
• Remove rear cowling.
• Disconnect all plug-in connections of the
power module.
• Loosen and remove the fixation screws of the
power module using the open-end spanner
8 mm.
• Remove power module
• Re-assembly of the power module is carried out in the reverse order.
• Check all vehicle functions.