Invacare G50 - 7.19 Repairing a flat tyre; 7.19.1 Repairing a flat tyre (type 4.00-8 pneumatic tyres)

Invacare
®
- G50
SERVICE INSTRUCTIONS
97
7.19 Repairing a flat tyre
WARNING: Danger of crushing!
The mobility device is very heavy. Injury hazard to hands and feet!
• You should seek help from a second person.
Injury hazard caused by uncontrolled movement of the mobility device!
• Switch the power supply off (ON/OFF key).
• Engage the drive.
• Before raising the vehicle, secure the wheels by blocking them with wedges.
7.19.1 Repairing a flat tyre (type 4.00-8" pneumatic tyres)
Pre-requisites:
• Torx TX-40 spanner
• 5 mm Allen key
• Repair kit for tyres with inner tube or a new hose.
• Talcum powder
Removing the wheel
• Jack up the vehicle (place a piece of wood under
the frame).
• Use the Torx spanner to remove the 4
countersunk screws (1).
• Remove the wheel from the wheel hub.
PLEASE NOTE
Assembly is carried out in the reverse order. Please ensure that the wheel is re-fitted on the
same side and in the same running direction it was in before removal.