Invacare G50 - Page 86

SERVICE INSTRUCTIONS
Invacare
®
- G50
86
• Carefully pull the seat upward and to the front.
Depending on the position of the tilt of the seat,
this will remain in the position shown on the right
or it will swivel further to the front.
• The fuse holder is positioned on the top of the
batteries.
• Open the fuse holder cover.
• If the strip fuse has blown, determine the
cause of the fault and remedy if necessary.
The main fuse should only be replaced when
the fault has been remedied.
• Use the 8mm open-ended spanner to
unscrew the nuts (2) on the strip fuse.
• Replace the strip fuse.
• Installation is carried out in the reverse order.
• Check all vehicle functions.