SV-DA200 series AC servo drives Running and operation
‐79‐
5.2.5.5 Operation flowchart of inertia identification
Press MODE key to the auxiliary function mode. Press UP/DOWN key to the menu, and
press SET key to the interface. The interface will display . Press SET key to start the inertia
identification. After finishing, the result will be displayed for about 3 seconds and saved
automatically. It will return to eh parameters after displaying for about 2 seconds.
5.2.5.6 Operation flowchart of absolute encoder clear
If the multi-turn encoders are used, the zeroing of mechanical system is needed after first power on.
Press MODE key to switch to the auxiliary function mode. Press UP/DOWN key to the
menu, and press SET key to the interface. The interface will display . Press SET key to
start the clearing, the interface will display , and after finishing, it will display ; if
the encoder model is not matched or the operation is failed, it will display .
To Next Page
Loading...
