Iridium GO! exec - Included Accessories and How to Use Them

22
a. AC Wall Charger with International Plug Kit
b. DC Car Charger
c. USB C Cable
Included Accessories and How to Use Them
AC Wall Charger:
The Iridium GO! exec comes with a 110-240v AC charger with USB-C output that allows the
device to fully charge in under 3 hours. Connecting other AC chargers to the USB-C charging port
may also work, but if the charger is lower power it will take longer to charge. The Iridium GO! exec
will detect chargers under ~18W and will warn users that some features may not be supported.
Using the Supplied AC Charger:
Select the appropriate international adapter depending on your requirements.
• For the USA the pins just need to be folded out from the charger.
• For other countries the pins should be folded in and the appropriate adapter slid onto the
folded pins until it clicks in.
• Then plug in one end of the supplied USB C cable to the wall charger and the other end to your
device charging port.
NOTE: The port’s IP65 rating isn’t maintained when the connector is inserted
DC Car Charger
The Iridium GO! exec is supplied with a DC car charger suitable for use in 2 pin cigarette lighter
sockets supplying 12-24 v often used in automobile and marine environments.
The DC charger will allow the device to fully charge in under 3 hours using the supplied USB-C
cable. Connecting other DC chargers to the USB-C charging port will also work, but if the charger
is lower power it will take longer to charge. The Iridium GO! exec will detect chargers under ~18W
and will warn users that some features may not be supported.
Using the Supplied DC Charger
• Plug the DC charger into the automobile auxiliary power outlet. When the socket is powered,
the DC charger will show a blue light.
• Connect one end of USB-C cable to the USB-C output on the supplied charger and connect
the other end of the USB-C cable to your device charging port.
NOTE: The port’s IP65 rating is not maintained when a connector is inserted.