TH4330,4290,4260
90
PRE-DELIVERY INSPECTION
- Check that engine oil level is correct.
- Check that coolant level is correct.
-Check fan belt tension, 1/2” (10 mm) deflection,
when subjected to a force of thumb pressure.
- Check that transmission oil level is correct.
- Install a sufficient amount of No.2 diesel fuel to com
plete pre-delivery service.
- Ensure clean and tight cable connections at battery.
Battery must be securely mounted.
- Check air cleaner, element, hoses, and clamps for
correct installation.
- Check brake pedal linkage for correct free-travel.
-Check steering and brake linkage cotter pins and
lock nuts for secure installation.
- Check filter element and, all connections and clamps
for hydraulic pump and filter.
- On 4-WD models, check oil level in front drive axle.
Place fuel filter shutoff valve in the “ON” position.
Take up position in operator’s seat and engage park-
ing brake.
- Place all shift levers in neutral.
- Place rear PTO and mid PTO selector levers in neu-
tral.
NOTE: Engine will not start unless range shift lever is
selected to neutral, rear PTO, and mid PTO
selector lever are in neutral.
- Set throttle lever at half to full throttle and turn main
switch counterclockwise 5-10.
- Turn main switch clockwise to “ON”. Oil pressure and
alternator warning lights will illuminate. Hold in “ON”
position 1-2 seconds.
- Turn main switch to “START” to crank the engine.
Release key to “ON” position the moment engine
starts. Check that warning lights go out.
- Allow engine to warm up to operating temperature at
about 1500 rpm.
-Operate Tractor to confirm it operates smoothly at all
speeds including four-wheel drive (if so equipped).
- Operate PTO to see that it functions properly.
- Check that all lights and instruments operate proper-
ly.
- Check brakes for balanced operation.
- Check warm engine low idle speed, 850-900 rpm.
- Check warm engine high idle speed, 2500-2750 rpm.
- Set throttle lever at idle, shut off engine and check
Tractor for coolant, lubricating oil or fuel leaks.
- Check that safety start system functions correctly.
- Lubricate all fittings.
- Check tire inflation pressures.
- Check front wheel toe-in.
- Test anti-freeze to see that it is adequate for local cli-
mate condition.
NOTE: Factory fill is set to –30 F(-34 cent-degrees).
- Check to see that all safety decals and safety switch-
es are in place.
- Clean and polish sheet metal as necessary.
- Fill fuel tank to prevent moisture accumulation.
- Review this Operator’s Manual with the customer
when delivering or demonstrating Tractor..
To Next Page
